Remote Control - Sony HT-S100F Manuel D'instructions

 Make sure that the USB device is
securely connected to the
port (page 18).
 Check to see if the USB device or a
cable is damaged.
 Make sure that the USB device is on.
 If the USB device is connected via a
USB hub, disconnect it and connect
the USB device directly to the system.
Mobile Device Connection
BLUETOOTH connection cannot be
completed.
 Make sure that the BLUETOOTH
indicator on the Bar Speaker is lit
(page 8).
 Make sure the BLUETOOTH device to
be connected is turned on and the
BLUETOOTH function is enabled.
 Bring the BLUETOOTH device close to
the system.
 Pair this system and the BLUETOOTH
device again. You may need to cancel
the pairing with this system using
your BLUETOOTH device first.
 If the BLUETOOTH function is set to
off, set it to on (page 24).
Pairing cannot be achieved.
 Bring the BLUETOOTH device close to
the system.
 Make sure this system is not receiving
interference from a wireless LAN
device, other 2.4 GHz wireless
devices, or a microwave oven. If a
device that generates
electromagnetic radiation is nearby,
move the device away from this
system.
 Pairing may not be possible if other
BLUETOOTH devices are present
around the system. In this case, turn
off the other BLUETOOTH devices.
Sound of the connected
(USB)
BLUETOOTH mobile device is not
output from the system.
 Make sure that the BLUETOOTH
indicator on the Bar Speaker is lit
(page 8).
 Bring the BLUETOOTH device close to
the system.
 If a device that generates
electromagnetic radiation, such as a
wireless LAN device, other
BLUETOOTH devices, or a microwave
oven is nearby, move the device away
from this system.
 Move the USB 3.0 device and its cable
away from this system.
 Remove any obstacle between this
system and the BLUETOOTH device or
move this system away from the
obstacle.
 Reposition the connected
BLUETOOTH device.
 Switch the wireless LAN frequency of
any nearby wireless LAN router or PC
to 5 GHz range.
 Increase the volume on the
connected BLUETOOTH device.
The sound is not in sync with the
image.
 When you are watching movies, you
may hear the sound with a slight
delay from the image.

Remote Control

The remote control of this system
does not function.
 Point the remote control at the
remote control sensor on the Bar
Speaker (page 8).
 Remove any obstacles in the path
between the remote control and the
system.
 Replace both batteries in the remote
control with new ones, if they are
weak.
29
US