Table des Matières
Publicité
EN
4. FITTING OF THE (+) BATTERY CABLE OF THE HTL
For HTL with battery switch, follow the instructions
through §4.1 to §4.3, §4.5 [See also chapter 6 - Options]
For HTL without battery switch, follow the instructions
through §4.4, §4.5 [See also chapter 6 - Options]
§4.1 - Standard control box with battery switch and re-
movable key (order ref. S008.B...)
The (+) battery cable from the battery switch in the control
box to the starter solenoid in the power pack is normally
premounted ex works. The connection of the (+) battery
cable from the batteries is done under a protective hood at
the rear of the control box. [See Fig. 4.1]
Table 4.1
1
Main fuse 250A used for trucks
2
Main fuse 250A used for (semi-) trailers
3
(+) battery cable from the main fuse on the vehicle
battery to the incoming pole of the battery switch in
the exterior control box of the HTL
4
Exterior control box
5
Battery switch E2007
6
Hood of the control box, with 2 gland nuts
7
(+) battery cable from the outgoing pole of the bat-
tery switch to the incoming pole of the starter sole-
noid
8
Incoming pole of the starter solenoid
Dismount the hood. Lead the (+) battery cable coming
from the battery through the gland nut. Connect the eye of
the (+) battery cable to the free pole of the battery switch,
and lock the mounting nuts tightly.
DHOLLANDIA
4.1
1
2
17
5
3
8
4
6
7
Publicité
Table des Matières
