Peg-Perego primonido new Culla Notice D'emploi page 17

absorption device built directly into the shell, below the
padding: do not remove it.
• This product is only suitable for children who are unable to
sit up by themselves.
• This product is designed for children from birth up to a
weight of 9 kg. When used in vehicles it is designed for
weights of up to 10 kg.
• Only use the product on surfaces that are hard, horizontal
and dry.
• Do not leave other children playing unattended near the
carriage.
• Take care when adjusting the mechanisms (handle,
backrest) with the child present.
• Regularly check the handle (or the handles) and the
bottom of the pram to make sure that there are no signs of
breakage or damage.
• When using the pram with a stand, check the maximum
length of the carriage specified on the stand.
• The pram is intended for transportation purposes and
should not replace the cot at home.
• Do not use this product after 7 years from the date of
production indicated on the structure. The natural ageing
of the materials may mean that it is no longer compliant
with standards.
Instructions for use
Using the pram
1• HOOD AND COVER: to attach the hood, insert the clips into
the holes (fig_a) and button it onto the back. Fasten the
press studs on both sides of the cover (fig_b).
2• BACKREST ADJUSTMENT: pull the handle outwards and
rotate it clockwise to raise the backrest or anticlockwise to
lower it.
3• ROCKING POSITION: the pram has extractable feet under
the base which can be adjusted to allow the child to rock
(fig_a) or a remain still (fig_b). Rotate the feet outwards to
transform the pram into a comfortable cot (fig_c).
4• FOUR SEASONS SYSTEM: as shown in the figure, it is
possible to adjust the product's air circulation from the
base in order to prevent condensation.
Move the lever to blue for a cool, well-ventilated
environment (summer), or to red to limit the intake of air
(winter).
5• CARRIER STRAPS: to move the pram, lower the hood and
extract the carrier straps from the side pockets (fig_a). It
can also be carried by the Ganciomatic handles (fig_b).
6• BORSA: satchel with pad for changing baby's diaper.
Fastens to the chassis.
Ganciomatic System
7• The Ganciomatic System enables you to fasten the
bassinet quickly and easily, with one simple operation, to
the Ganciomatic base of the Bassinet Stand and to all the
PegPerego Ganciomatic chassis, excluding the Duette and
Triplette SW chassis (to be bought separately).
To attach the pram, put it on the chassis and press with
both hands until it clicks into place.
Always apply the brakes on the chassis before attaching
and removing the pram.
IMPORTANT: Check that the pram is properly attached.
8• IMPORTANT: exclusively for the BOOK chassis, before
fastening the bassinet, extract the two little feet on the
exterior base of the bassinet, level with the child's head (as
shown in the figure). Place the carrycot on the chassis and
press down with both hands until it clicks into place.
9• To release the pram, move the clip on the Ganciomatic
handle in the direction of arrow_a while pressing it in
(arrow_b) and lift the pram until it comes free (arrow_c).
Removing the lining
10• REMOVING THE LINING OF THE PRAM: Unbutton the
cover and the hood. Press the fasteners and pull the hood
upwards to release it (fig_a). Raise the backrest and remove
the mattress pad (fig_b). Unbutton (fig_c) and remove the
inner lining (fig_d).
Padding cleaning instructions
Brush the fabric parts to remove dust.
• When washing, closely follow the instructions stated on
the label sewn into the cover.
• Do not use chlorine bleach.
17