Functioning Of The Led's - Aritech DIGITALK 2000 Guide D'installation

Adjustments at the receiver
channel CH (➨9)
channel 1
1 2
O
N
channel 2
1 2
O
N
channel 3
1 2
O
N
channel 4
1 2
O
N
coding jumper coding jumper
GND (➨3) connecting clamp 2 GND is
connected with housing
alarm response sensibility 50-300ms (➨12)
The alarm response sensitivity is the period during which the IR beam needs to be
interrupted before an alarm is activated.
50 300
fast slow
running - 50ms

Functioning of the LED's

The operation of the LED indicator depends on the adjusted mode. In the alignment mode, the
receiver LED's show the alignment signal (see Alignment). In the operating mode, the state of the
system is shown in the following table.
When a system is armed, all lights on the receiver are unlit.
LED
7
6
5
4
3
2
1
disqualification DQ (➨10) Mode MO (➨11)
5 sec.
10 sec.
15 sec.
30 sec.
Coding jumper removed
Connecting clamp 2 GND is
not connected with housing
walking - 150ms
Transmitter
functioning-LED (alignment) (➨8)
–
–
–
–
–
–
-16-
Alignment upper parabolic mirror
Operating mode indoor
Alarm output at disqualification
Alignment parabolic mirror below
Operating mode outdoor
Without alarm, if only disqualification
Indication of crossillumination active
slow walking - 300ms
receiver
alarm is active (➨14)
first alarm memory is active (➨15)
disqualification is active (➨16)
functioning LED (➨17)
–
–
–