Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CAUTION: To avoid overflowing the filter holder, the carafe must fit
securely into the coffeemaker with the lid on. If not properly positioned
on the heating plate, it could cause hot water or hot coffee to overflow.
4. Open the coffee maker lid (B), insert the filter holder (I) by using the two handles
on either side. Make sure it is securely pushed down and locked into place. Then
insert a standard #4 cone paper filter or the permanent filter (J) into the filter holder
(I). Use a fresh paper filter or clean the permanent filter for each new brew cycle
- Fig. 4 and 5.
5. Add about 10 flat spoons (S) of ground coffee for 12 cups. Experiment with the
amount of coffee used in order to adjust the flavor to your taste - Fig. 6.
6. Close the top lid making sure it is securely closed - Fig. 7.
7. Press the On/Off button (K). The light (M) will illuminate, indicating that your coffee
maker has begun the brewing cycle.
CAUTION: The coffee maker becomes very hot during the brew cycle.
Please handle with care.
Note: At any time during the brewing cycle, you can turn the coffee maker off by
simply pressing the On/Off button (K). No light (M) will be illuminated, indicating that
the coffee maker is off.
8. When the brewing cycle is completed, the On/Off light (M) will stay illuminated as
the keep warm cycle starts.
The anti drip valve will prevent any remaining coffee from dripping onto the heating
plate. Ensure that the carafe is replaced on the heating plate after serving.
Notes: When the brewing cycle is finished, there will still be hot liquid in the filter
basket. Wait a few minutes for the rest of the liquid to drip through into the carafe.
-
The keep warm function will operate for up to two hours. During the keep warm
cycle, the On/Off light (M) will stay illuminated. At any time you can stop the keep
warm cycle just by pressing the On/Off button (K). The On/Off light (M) will switch
off.
9. Open the top lid and carefully remove the filter holder by grasping the tabs on each
side of the filter holder, and lifting straight up from the coffee maker. Discard the
used coffee filter and grounds. If you use the permanent filter, wash it immediately
(see section "CLEANING") - Fig. 9 and 10.
Note:
-
If two or more pots of coffee are to be made it is recommended that the
coffeemaker be allowed to cool for 3 minutes between brewing.

Auto Shut-Off

As a convenience, your coffee maker has been designed with an Auto Shut-Off
feature. When the brewing cycle is completed, the coffee maker will shut off
automatically after 2 hours.
4

Publicité

Table des Matières
loading

Table des Matières