Programming Your Coffee Maker - Krups KM750850 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PROGRAMMING YOUR COFFEE MAKER

Auto On Setting
1. Check to ensure that the clock is set to the correct time. If the time is incorrect,
follow the instructions in the "SETTING THE CLOCK" section.
2. Follow steps 1 through 7 in the "Making Coffee" section.
3. Press the Programing button (O).
4. Use the Hour (P) and Min (Q) buttons to set the desired start brewing hour(see
section "SETTING THE CLOCK"). Refer to the AM and PM indicators on the left
side.
5. Press the Auto on button (L). Auto On Indicator Light (N) will illuminate to indicate
that the coffee maker is programmed. The digital clock will continue to show the
current time.
6. Once the preset brew time is reached, the coffee maker will automatically initiate
the brew cycle. The On/Off light (M) will illuminate, indicating that your coffee
maker has begun the brewing cycle. The Auto Light on (N) will switch off.
7. To cancel a preset brewing cycle, press the Auto on button (L) - the preset brew
cycle is cancelled when the Auto Light (N) is no longer illuminated. For your
convenience, your coffee maker will remember your preset brewing time. Simply
press the Auto on button (L) to activate the preset brewing cycle. To change the
preset brewing time, follow steps 3 through 7 above.
TIPS & ADVICE
At any time during the brewing cycle, you can turn the coffee maker off
or cancel the brewing cycle, by simply pressing the On/Off button (K). No
buttons will be illuminated, indicating that the coffee maker is off.
Pause & serve
This feature allows you to interrupt the brewing cycle and pour a cup of coffee
before the entire carafe is finished brewing.
While this will temporarily stop the coffee from dripping into the carafe, it does not
stop the brewing cycle. After serving, the carafe should be immediately returned to
the heating plate to prevent the filter holder from overflowing. Make sure the carafe
is positioned firmly against the back of the coffee maker. Do not remove the carafe
for longer than 20 seconds.
This setting should be used when the carafe is half full or less, to ensure the coffee
quality is maintained.
The Stay Warm setting will continue to operate as long as the unit is on and will
shut off automatically after 2 hours.
5

Publicité

Table des Matières
loading

Table des Matières