Maintenance And Care; Technical Data; General Safety Regulations - Güde 2600 PRO Mode D'emploi

Scope of Supply
Figure 1:
1. Left/Right
2. Handle
3. Pneumatic connection
4. Clutch
Unit
PNEUMATIC DRILL 2600 PRO
Professional pneumatic drill 3/8 with a fast left-right.
Switch. Pistol handle with a rubber coat to ease the vie
vibrations.
GB
Declaration of EU conformity
We, Güde GmbH & Co. KG Birkichstraße 6,
74549 Wolpertshausen, Germany
Hereby declare that the concept and structure of the types if
instruments shown below are corresponding to the basic requirements
of the EU directives of safety and health.
If the instrument is changed and the change was not
consulted with us, this declaration will loose its validity.
Marking of instruments 2600 PRO Ord.No.: 75150
Date/signature of the maker
The signatory's data: Arnold, executive officer
Respective EU directives:
89 / 392 / EWG; 91 / 368 / EWG; 93 / 44 / EG
Harmonised standards used:
EN 792; DIN 45635

Technical Data

2600 PRO
Operating pressure
Air consumption
Drill mm
Air connection screw
Max. idling speed
Recommended hose Cross-section
Noise data Lwa
Weight
Ordering no. 75150

General Safety Regulations

Operating manual should be completely read
before the first use. If doubts regarding the unit
operation arise, ask the producer (servicing
department) for advice.
Operation
Do not direct the rotating end of the tool against
yourself or against other persons. Connect the
tool with the air supply hose
Use pneumatic tools under allowed operating
pressure only.
14.10.08
:
6,3 bar
113 – 240 l/min
1-10
¼"
-1
2600 min
10 mm
98 dB
1,1 kg

Maintenance and Care

Only trained persons ate allowed to do the
maintenance.
Observing warning commands shown in the
Lasting and trouble-free function of your ratchet
screwdriver is grounded on regular lubrication.
Use only a special tool oil. Pick up a possibility of
lubrication: Use only a special tool oil. Pick up a
possibility of lubrication.
Ways of lubrication are following:
a) Via a beam added lubricator
The full maintenance unit include a beam
added lubricator and is placed on the
compressor.
b) Via a lubricator on the piping
A lubricator installed on piping supplying the
unit with sufficient amount of oil in an
immediate distance from the unit
(approximately 50 cm).
c) Manually
If there is no maintenance unit or a lubricator
on piping, 5-6 drops of oil should be put in
pneumatic connection before every putting in
operation.
Store the pneumatic tool in dry rooms.
14