Attaching The Fan Blades; Installing The Lamp Ballast Assembly - Kichler 52 BASICS PRO DESIGNER Manuel D'instructions

ATTACHING THE FAN BLADES

CAUTION: Remove the rubber shipping blocks attached to the face of the motor. These
blocks keep the motor from shifting during shipping and MUST be removed during
installation.
Step 1. Attach the blade to the blade bracket using the screws and washers as shown in
Figure 17. Start screw into bracket. Repeat for the two remaining screws.
Step 2. Make sure the blade is straight and tighten each screw.
Step 3. Fasten blade assembly to motor using "Pre-Installed" mounting screws in the
blade bracket.

INSTALLING THE LAMP BALLAST ASSEMBLY

NOTE: Before continuing installation, confirm that the power is still turned off at the main
circuit breaker or by removing the correct fuse. Turning power off using a wall switch is
not sufficient to prevent electrical shock.
Step 1. Loosen the three mounting screws on the light plate, then remove screw.
Hold the light kit close to the light plate and connect the white wires from the light plate
and the fan by pushing the connectors together. Follow the same procedure with the
black wires (Fig. 18).
Step 2. Tuck the connections neatly into the light plate. Place the key holes on the light
plate over the three screws previously loosened from the light plate and turn the light plate
until it locks in place. Secure by tightening all three screws (Fig. 18).
14 | KICHLER.COM
Screws
Washers
Screws
Blades
Blade brackets
Fig. 17
Black Light plate
White
Wire connector
White
Black
Screws
LED light
Fig. 18