NESTOR MARTIN STANFORD 9 Mode D'emploi page 50

OPERATION WITH COAL
Thermostat n° 2 enables you to regulate the tempo of the stove by adjusting
the air intake opening. The thermostat will automatically control the fire
depending on the position it is set. The thermostat responds to both the
stove and room temperature. ( - = low heat output + = maximum heat output)
for normal operation use 1/2 to 3/4 position. For slow burning do not
completely shut off the thermostat (the thermostat has to be set with a 5
mm minimum opening) (see page 3).
FUELLING THE STOVE WITH COAL
To prevent smoke blowing into the room to be heated and to recover the fire to burn
up quickly, follow these recommendations:
Open the thermostat n° 2, allow the fire to recover. Open the damper (3). Close thermostat n° 2, open
the door. Feed in the coal making a heap on the embers over the oscillating grate. Close the door and,
open thermostat n° 2 to its maximum and leave the fire to burn for 5 to 10 minutes. Close the damper.
Adjust the thermostat n°2 depending on the tempo of the stove and the heat required.
ASH REMOVAL COAL
Empty the ash pan regularly to prevent the ash from spilling over and obstructing the
passage of air to the grate. (Do not allow ash to build up and touch the under side of the
grate). To remove the ash from the stove, operate the oscillating grate using handle n° 4.
Open the ashpan door by turning clockwise the handle. Remove the ashpan and empty it.
Put the ashpan back and close the ashpan door by turning the handle counterclockwise. This
door must be closed to prevent severe damage to the stove.
The tool provided for removal of the ash pan should not be used alone to carry the ash
pan. Use the glove and hold ash pan on both sides.
FUELS
Wood (seasoned)
Lignite briquettes (brown coals)
reconstituted wood Iogs
Peat (Peat briquettes)
Smokeless coal
50
4
C07100DA352