Cleaning Your Vacuum Cleaner; Guarantee - Rowenta Silence Force Extreme Compact RO56 Série Mode D'emploi

CLEANING AND MAINTAINING
• Make sure that the microfilter is in the right position before
closing the casing again (fig.28).
The microfilter (ref. ZR9014 01) is available from your retailer
or at Approved Service Centres.
TROUBLESHOOTING
IMPORTANT: As soon as you notice that your
vacuum cleaning is not working as well as it should
be and before carrying out any checks, switch it off
using the On/ Off button.
If your vacuum cleaner won't start
• The appliance has not got any power: check that the
appliance is correctly plugged in.
If your vacuum cleaner doesn't have any suction power
• An accessory or the flexible hose is blocked: unblock the
accessory or the flexible hose.
• The cover won't close properly: check the positioning of the
bag, bag support and (H)EPA filter cassette and close the
cover.
If your vacuum cleaner has less suction power, makes noise,
whistles
• An accessory or the flexible hose is partially blocked: unblock
the accessory or the flexible hose.
• The bag is full or saturated with fine dust: replace the bag.
• The filtration system is saturated: change the filter cassette
(H)EPA (ref ZR0029 01).

GUARANTEE

• This appliance has been designed for domestic use only; the
manufacturer will accept no responsibility in the event of any
inappropriate use or failure to comply with the instructions
and the guarantee will cease to apply.
4 • Cleaning your vacuum cleaner
Wipe the body of the appliance and the accessories with a soft
cloth (fig.29). Do not use detergents, chemical or abrasive
products.
• The mechanical power control switch (20c) is open: close the
power nozzle adjustable manual power switch.
If the change bag light stays on Red
• The bag is saturated: replace the bag.
If the cover won't close (presence sensors 13, 14, 16)
• Check that that the bag support is fitted as well as the bag and
that it is positioned correctly.
• Check that the (H)EPA filter cassette is fitted or that it is
correctly positioned.
If the nozzle is difficult to move
• You can reduce the power by opening the power nozzle
adjustable manual power switch (20c) or by moving the
electronic power control (9) to a lower position.
If the power cord does not rewind completely
• The power cord is slowed down when rewinding: pull the
power cord out again and press the power cord rewind button.
If a problem persists, take your vacuum cleaner to your local
Rowenta Approved Service Centre. To find a list of Authorised
Service Centres, contact Customer Services, the contact
details for which you will find on the enclosed international
guarantee card.
• Read the instructions for use carefully before using your
appliance for the first time: any use of the appliance which
does not conform to these instructions will release Rowenta
from any liability.
11
EN