Cleaning And Servicing - Rowenta AQUA EXCEL Mode D'emploi

• Turn the carpet washer on. (fig.19)
EN
• Switch on the pump. You will hear a vibration noise for a few seconds until the pump starts va-
cuuming the liquid. This noise is normal and indicates that the pump is working. (fig.19)
• Turn the tap lever until the liquid starts to flow up to the extraction nozzle in a straight line towards the
surface that is to be cleaned. (fig.20)
• Release the trigger's lever to stop the spray jet.
• So as to remove as much liquid as possible from the surface, repeat the vacuuming process until
whole area has been cleaned.
• Stop the pump at the end of the cleaning procedure by pressing on the trigger in order to remove all
the water remaining in the water pipe.
IMPORTANT If there is not enough water or cleaning product to do the cleaning, switch off the carpet
washer and fill the reservoir(s).
5 • ACCESSORIES FOR WASHING
Large spray or extraction nozzle
For cleaning large surfaces, such as rugs or hard floors.
Flap
Small spray extraction nozzle
For cleaning small surfaces, like sofas, armchairs etc.
Accessories for cleaning glass surfaces
For cleaning glass surfaces, such as windows, mirrors etc.
It is used like the little spraying nozzle.
IMPORTANT When cleaning hard floors and for absorbing liquids on hard floors, we recommend you
use the extraction nozzle (points 27 and 28 in the description) with or without the flap.
• Slide the flap over the large extraction nozzle in the direction of the arrow. (fig.21)
• Clean the surfaces. (fig.21).
We recommend you don't walk on a hard floor which has just been cleaned in order to avoid leaving
marks.
IMPORTANT The risk of slipping over on floors is greater when they have just been cleaned.
For very dirty surfaces
Only use a cleaning liquid when you are cleaning very dirty surfaces for the very first time. To avoid de-
figuring rugs, only use cleaning liquid on a limited area. Next, stop the pump, switch on the carpet wa-
sher and vacuum the dirty water.
• Unplug the water pipe on the side of the liquid valve and the trigger side as well as the connection
tube next to the pressure switch by turning it in the direction of the arrow. (fig.22).
• Unplug the flexible hose's power nozzle (fig.22).
• Attach the small spray nozzle to the power nozzle. (fig.23).
• Connect the pipe's connector to the trigger. (fig.23).
• Clean the surfaces. (fig.23).

CLEANING AND SERVICING

Turn off the carpet washer and unplug the power cord. Gently pull on the power cord to deactivate the
braking. The cable then winds in automatically. Only put the cable away if it is dry. (fig.24).
1 • AFTER ABSORBING WET DIRT, LIQUIDS OR AFTER WASHING
• Vacuum clean water in order to clean the accessories.
• Unplug the liquids pipe from the vacuum opening.
• Remove the reservoir holder from the base.
10