Special Accessories; Technical Data - Martin Yale paper monster L71 286-4C Instructions D'opération

GB
EMPTYING THE RECEPTACLE (fig. 4):
When the receptacle is full, the machine turns off
automatically. Pilot lamp lights up (4) (fig. 3).
Proceed as follows:
- Turn the function switch (1) (fig. 1) in position „
".
- Remove the receptacle from in front of the
machine and empty its contents.
- Replace the empty receptacle under the machine
and push all the way to the back.
Note: The machine only runs when the receptacle
is fully pushed in!
MATERIAL JAM IN THE MACHINE:
If too much paper is fed to the cutting system the
cutting system will jam.
Proceed as follows:
- Turn the function switch (1) (fig. 1) briefly to
position „ ", then in position „ ".
- Cutting system runs in reverse, frees excess
paper and stops.
- Tear off the excess paper over the feed slot
and then turn the function switch (1) (fig. 1) to
position „ ".
- The cutting system runs forward and cuts the
remainding paper left in the cutting system.
- Continue the shredding process with less pa-
per.
Description
Lubrication bottle, 125 ml
Note: For orders of special accessories and spare parts, please contact your dealer.
OPERATION
MOTOR PROTECTION:
The motor shuts down automatically, should it
become overloaded. Turn the function switch in
position „ ".
Allow the motor to cool down for 25 minutes
(depending upon room temperature) and then
continue shredding.
DISPOSING OF THE MACHINE:
Dispose
environmentally sound fashion at the end
of its useful service life. Do not dispose of
any of the parts included in the machine
or its packaging with household trash.

SPECIAL ACCESSORIES

fig. 4
MALFUNCTION
DISPOSING
of the machine in
Order-No.
99943
5
MAINTENANCE
CLEANING THE PHOTOCELLS:
If paper particles should come to rest in the inlet
guide (for example after a paper jam) it is possible
that the machine will not turn off, due to the broken
light barrier.
To remove these paper strips and also to clean
the photocell, pass another sheet of paper through
the feed slot, or switch the machine to reverse and
wipe both „eyes" of the photocell with a brush.
MAINTENANCE OF THE
CUTTING MECHANISM:
Cross-cut cutting mechanisms must be
oiled after a certain operating time (after
approximately 15 minutes of continuous
use).
Proceed as follows:
Spread some oil on a sheet of paper and then
feed it into the cutting mechanism through the
paper feed slot.
The paper is drawn in and the oil thus gets into
the cutting mechanism.
To re-order the special oil, see "SPECIAL
ACCESSORIES".
TIP FOR ENERGY SAVING:
Please make sure that the shredder is switched
off over night (turn the function switch (1) (fig. 1)
in position „ ").
CHECKLIST IN THE EVENT OF FAULTS:
If the machine does not work, check the following
points:
- is the mains plug connected to the mains?
- is the function switch (1) switched on?
- is the receptacle pushed in?
- is the receptacle full?
Follow the instructions in "EMPTYING THE
RECEPTACLE".
- is there a material jam in the machine?
Follow the instructions in "MATERIAL JAM IN
THE MACHINE".
- Has the motor been overloaded?
See "MOTOR PROTECTION".
If none of the above applies, please contact
your dealer.
an

TECHNICAL DATA

Cutting width:
Cutting capacity:
Supply voltage:
Working width:
Noise generation:
Power:
Intermittent operation:
Dimensions (WxDxH):
Weight:
L71
4x44 mm
6 sheets (70g/m 2 )
see name plate
220 mm
65 dB(A)
see name plate
2 min ON
25 min OFF
405x96x320 mm
approx. 4,1 kg