Switching Off - Russell Hobbs 13632-56 Mode D'emploi

12 Check the lid is fully closed before switching the kettle on, otherwise it may not switch off.
13 Check the kettle is properly located on the stand before switching on.
14 Don't switch on unless the kettle contains at least 2 cups of water.
15 Don't fill past MAX, or it may spit boiling water.
16 Remove the kettle from its stand before filling or pouring.
17 Keep the kettle, stand, cable, and plug away from sources of heat.
18 Don't use the kettle for any purpose other than heating water.
19 Use the kettle only with the stand supplied (and vice versa).
20 This appliance must not be operated by an external timer or remote control system.
21 Don't operate the appliance if it's damaged or malfunctions.
22 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or
someone similarly qualified, in order to avoid hazard.
before using for the first time
Fill to MAX, boil, discard the water, then rinse. Do this three times, to remove manufacturing
dust, etc.
positioning
1 Put the stand on a stable, level surface.
2 Route the cable so it doesn't overhang, and can't be tripped over or caught.
3 Wind excess cable beneath the stand
filling
caution
keep clear, steam may escape from the lid.
4 Remove the kettle from the stand.
5 Use the lid knob to remove the lid.
6 Fill with at least 2 cups of water, but not above MAX
7 If you overfill, the kettle may spit boiling water.
8 Replace the lid.
9 Check the lid is closed, or the kettle won't switch off when it boils.
switching on
10 Plug the stand into the wall socket.
11 Put the kettle on the stand – take care not to spill.
12 Move the switch to 1.
13 The light will come on, and the kettle will heat up.

switching off

14 When the water boils the kettle will switch off and the light will go out.
15 To switch off manually, move the switch to 0.
16 Lifting the kettle off the stand will also switch the kettle off.
general
17 Remove the kettle from the stand before pouring.
18 To avoid the risk of splashing, pour slowly and don't over-tilt the kettle.
19 Don't tilt the kettle backwards, water might get on to the control area. If this happens, let the
kettle dry before use – sit it somewhere warm for 12 hours.
20 When you lift the kettle, you may see moisture on the stand. Don't worry – it's the steam
used to switch off automatically, which then condenses and escapes via vents under the
kettle.
21 You may see some discolouration on the floor of the kettle. Again, don't worry – it's due to
the bonding of the element to the kettle floor.
household use only
87