Operating Your Appliance; Using Your Appliance; On/Off Components; On/Off Switch - Napoleon Ascent Linear Série Manuel Du Propriétaire

When operating your appliance for the first time, there is a required burn-in process that cures materials used
to manufacture the fireplace that may emit both vapors and an odor. These are normal when operating a new
appliance for the first time. Ensure adequate air circulation is provided during burn-in process, if this was not
completed by the installer during installation.
2.1

using your appliance

To turn the appliance on:
A Turn the on/off switch on.
B After 3-5 seconds, the control will start a spark at the pilot, light the pilot and then the burner. The spark
period will last 60 seconds, or until the pilot has lit.
C When used for the first time, if the burn-in process was not completed by the installer; run appliance
continuously for 4 hours (burn-in).
D Turn the appliance off. Wait until appliance is completely cool before moving to the next step.
E Remove the safety barrier and firebox glass door. Clean firebox glass door (see "maintenance" section).
Replace firebox glass door and safety barrier.
For more detailed information, see your installation manual or contact your authorized dealer.
2.2

on/off components

|

On/off switch

(Not supplied)
Batteries must be disposed of according to the local laws and regulations. Some batteries may be
recycled, and may be accepted for disposal at your local recycling center. Check with your
municipality for recycling instructions.

2.0 operating your appliance

| Battery holder (including switch)
(Optional)
operating your appliance
|

Remote control

EN
ON
OFF
|
(Optional)
7
W415-3092 / 07.13.21