Making Adjustments; Leveling The Throat Plate; Squaring The Blade Vertically To The Table - Delta 36-6022 Guide D'utilisation

LEVELING THE THROAT PLATE

The front, rear and sides of the throat plate must be level with the surface of the table.
There are four screws pre-assembled to the table that are used to level the throat plate.
If the throat plate is not flush with the surface of the table, adjust these screws to ensure the entire throat plate is flush
with the table. They can be accessed and adjusted without removing the throat plate. Do not attempt to mount the throat
plate down using the throat plate leveling screws.
See Figures 47 & 47a.

SQUARING THE BLADE VERTICALLY TO THE TABLE

Place a framing square (B) on the table surface and against both blade and riving knife. The framing square should be in
full contact with the blade face and riving knife.
See Figure 48.
If it is not square, adjust the 0-degree stop as shown in "Adjusting The Bevel Stops" below.
See Figures 49, 49a, 50 and 50a.

MAKING ADJUSTMENTS

FIGURE 47
FIGURE 48
36
a
SCREW UNDER
THROAT PLATE