Horizontal Alignment; Vertical Alignment - Delta 36-6022 Guide D'utilisation

RIVING KNIFE POSITION AND ALIGNMENT

Horizontal Alignment

The plane of the riving knife appears to be twisted in comparison to the plane of the blade. (Can be seen looking straight
down on the blade and riving knife.)
If the riving knife has horizontal misalignment, adjust as follows using Figure 59 and Figure 61.
1. Loosen the two hex socket head screws (AA)
2. Adjust screw (BB2) to align the riving knife to the blade, if still out of alignment then adjust (BB3) until proper
alignment is achieved. Do not adjust (BB1).
3. Tighten screws (AA).

Vertical Alignment

The plane of the riving knife appears to be twisted in comparison to the plane of the blade from the bottom of the riving
knife to top of the riving knife. (Can be seen looking from the front of the saw.)
If the riving knife has vertical misalignment, adjust as follows using Figure 59 and Figure 62.
1. Loosen the two hex socket head screws (AA)
2. Make adjustments to (BB2) and (BB3), to align riving knife to the blade. No adjustment is needed for (BB1).
3. Tighten screws (AA).
FIGURE 61
FIGURE 62
44
a