Assembling Upper Stand - Delta 36-6022 Guide D'utilisation

ASSEMBLY
I1
dd
I2 cc
ee
a
FIGURE 1
TUBE INSERTS
SHOULDER
ON BOTTOM
TUBE INSERTS
SHOULDER
ON BOTTOM
LOCK PIN
I
FIGURE 2
a

ASSEMBLING UPPER STAND

Assemble upper half (I1) of upper stand assembly to lower half (I2) of upper stand assembly as shown in Figure 1 using
M8 x 75mm carriage screw (ee), spacer (cc) and M8 locknut (dd) to each side of upper stand assembly.
NOTE: I1 is attached to saw table assembly and secured with cable ties. Remove cable ties prior to assembling I1 and
I2.
NOTE: Orientation of I2 lock pin is on the right side of the assembly and orientation of I1 will have shoulder of tube
inserts on bottom as shown in Figure 2.
Finished upper stand assembly will appear as shown in Figure 2.
IMPORTANT: Tube insert shoulder on bottom.
11