Adjustments - Delta 96-110 Manuel D'utilisation

Before performing any adjustments, make sure the tool is unplugged from the power supply and the switch is in
the OFF position. Failure to heed this warning could result in serious personal injury.
This saw has been adjusted at the factory to make accurate
cuts. However, should your tile saw need adjustment after it
has been unpacked and assembled or due to machine wear,
the following steps will be used to align the table to the saw
blade.
NOTE: Do not start any adjustment until you have check
alignment with a square and made a test cut to ensure that
adjustments are needed for your tile saw.
To Square the Cutting Wheel to
the Table
Do not loosen any screws for this adjustment until you have
checked alignment with a square and made a test cut to
ensure that adjustments are needed for your tile saw.
• Unplug the saw.
• Remove upper splash tray (3)
• Use the provided Allen wrench to loosen hex socket bolts
(A) on the left rail.
• Place a framing square against the worktable fence and
flat part of the blade.
• Using Allen wrench to turn set screw (B) to adjust. Move
the rail until the fence is square with the blade. (Set
screws (B) are located on the outside ends of the rail.)
• Tighten the end hex socket bolts (A) to lock rail in place.
Then tighten remaining hex socket bolts (A).

ADJUSTMENTS

18
Figure 30
B
Figure 31
Figure 32
A