Maintenance; Keep Machine Clean; Maintenance Reminders; Troubleshooting - Delta 36-6022 Guide D'utilisation

To reduce the risk of injury, turn unit off and disconnect it from power source before cleaning or
servicing, before installing and removing accessories, before adjusting and when making repairs. An
accidental start-up can cause injury.

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth.
NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.

MAINTENANCE REMINDERS

Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.
Specific areas which require regular maintenance include:
RIVING KNIFE CLAMP PLATE: Keep this area free of dust and debris buildup. Blow out area regularly with compressed
air.
NOTE: If the riving knife clamp can't move freely, have the saw serviced by authorized DELTA® Power Equipment
Corporation service center personnel.
WORM GEARS: Keep the bevel gears free of dust and debris buildup. Blow out area regularly with compressed air. Use
a lithium-based multipurpose grease as needed on these gears.
CLEAN SAWDUST BUILDUP OUT OF CABINET PERIODICALLY: NOTE: Debris can also be removed from the saw
from below the throat plate, inside the dust port.
For assistance with your machine, visit our website at www.DeltaMachinery.com for a list of service centers or call
DELTA® Power Equipment Corporation Customer Care at 1-800-223-7278.
FAILURE TO START
If your machine fails to start, check to make sure the prongs on the cord plug are making good contact in the receptacle,
and check reset button on power switch housing. Also, check for blown fuses or open circuit breakers in your power
line.
A complete line of accessories is available from your DELTA® Supplier, DELTA® Factory Service Centers and Delta®
Authorized Service Centers. Please visit our web site at www.DeltaMachinery.com for an online catalog or for the name
or your nearest supplier.
Since accessories other than those offered by DELTA® have not been tested with this product, use of
such accessories could be hazardous. For safest operation, only DELTA® recommended accessories
should be used with this product.

MAINTENANCE

TROUBLESHOOTING

ACCESSORIES

45