Anti-Kickbacks Pawls And Blade Guard - Delta 36-6022 Guide D'utilisation

Anti-Kickback Pawls and Blade Guard
Press spring loaded pin on the right side of the anti-kickback pawl assembly (N) insert over the middle slot on the riving
knife.
Once inserted, release the spring-loaded pin so that it pops back into place. Ensure it is locked in place by gently pulling
up on the anti-kickback pawl assembly (N).
Hold the blade guard assembly (M) as shown in Figure 26 and engage the pin with the slot in the riving knife. Pull blade
guard assembly up into place.
Rotate the blade guard so that the support arms are parallel to the table. Then lock the blade guard in place by
depressing the lock tab.
Verify the Blade Guard Assembly is properly locked in place. Do this by gently lifting up on the support arms after the
lock tab has been depressed. If blade guard is not properly locked onto the riving knife, support arms will raise up and
lock tab will spring up to the unlocked position.
See Figure 27.
To reduce risk of serious injury. It is important that you do not use the table saw if blade guard assembly
is not locked into place on the riving knife.
ASSEMBLY
PRESS
PIN
FIGURE 25
M
FIGURE 26
23
N
RIVING
KNIFE
LOCK
TAB
SUPPORT
ARMS
FIGURE 27