Description; Preliminary Checks - Genius ZODIAC 60 Mode D'emploi

4 DESCRIPTION





5 PRELIMINARY CHECKS

- The structure of the door must be suitable for fitting automation.
In particular, check that the door dimensions conform to
those indicated in the technical specifications, and that it is
sufficiently sturdy.
- Check if the door conforms to standards EN12604 and
EN12605.
- As it moves, the door must not encroach public areas
dedicated to pedestrian or vehicular transport.
- Check the efficiency of the door bearings and joints.
- Make sure that the door is friction-free. If necessary clean
and lubricate the guides with silicone based products, but do
not use grease, and, in any event, follow the manufacturer's
instructions.
- Check correct balance and if the opening mechanical stops





Fig. 4

Ceiling lamp

Rear door

Courtesy light

Plastic housing for ZODIAC 60 operator

Rear fitting

Sliding guide

Drive carriage

Release knob

 Door fitting bracket
Transmission unit

Front fitting and chain tensioner

Front fitting bracket

have been installed.
- Remove the door's existing closing mechanism to ensure the
door is closed by the automated system.
- Make sure there is a clearance of at least 35 mm between the
ceiling and the highest sliding point of the door (Fig.4).
- Check if the upper guide roller of the sectional door is in the
horizontal part of the guide while the door is closed (fig. 5).




Fig. 3
Fig. 5