Table Des Matières; Receiving Inspection - Gaymar Medi-Therm II Mode D'emploi

Before you begin . . .
Table of Contents
Section Description
1.0 Indications for Use .................................1
2.0 Safety Precautions ..................................1
3.0 Description ..............................................2
4.0 Operator Control Panel .......................4
5.0 Start-up Procedure ................................6
6.0 Modes of Operations:
BLANKET CONTROL .........................8
PATIENT CONTROL ............................9
MONITOR ONLY ................................10
7.0 Shutdown Procedure ...........................10
8.0 Safety Systems .......................................11
9.0 Troubleshooting ....................................12
10.0 Care and Cleaning ................................14
11.0 Blankets/Accessories ...........................16
12.0 Customer Training ................................16
13.0 Warranty ................................................16
14.0 Specifications .........................................17
Illustrations
Figure Description
1 Medi-Therm II System ..........................3
2 Medi-Therm II Control Panel .............5
3 Float ..........................................................6
4 Pinch Clamps ..........................................6
5 Quick-disconnects ................................7
6 Clik-Tite Connector .............................7
7 Probe Check Well ...............................13
8 Probe Check Well ...............................15
Gaymar® and Clik-Tite® trademarks are registered in the U. S. Patent and Trademark Office.
Gaymar®, Clik-Tite®, and Medi-Therm
© 1999. Gaymar Industries, Inc. All rights reserved.
Page
Page
are trademarks of Gaymar Industries, Inc.
TM

Receiving Inspection

Refer to the Medi-Therm II Service Manual for Receiving
Inspection and Check-out Procedures.
If you have any questions, contact your local dealer.
Dangerous voltage
Year of manufacture
Medi-Therm
TM
II