Triton TWX7 CS001 Instructions D'utilisation Et Consignes De Sécurité page 7

Troubleshooting
Problem
No function when ON/OFF Switch is operated
Poor cutting quality
Cutting profiles are inconsistent with measurements
Bevel angle setting is loose
Guarantee
To register your guarantee visit our web site at www.tritontools.com* and enter your details.
Your details will be included on our mailing list (unless indicated otherwise)
for information on future releases. Details provided will not be made available to any third party.
Purchase Record
Date of Purchase: ___ / ___ / ____
Model: TWX7CS001
Serial Number:________________________________ (located on tool housing)
Retain your receipt as proof of purchase.
Possible cause
No power
Power overload tripped circuit breaker
Defective ON/OFF Switch
Defective blade
Supporting Protractor Gauge (43) or Rip Fence (53) insufficiently fastened
Saw Blade (2) not calibrated
Sacrificial wood on Protractor Gauge (43) no longer
provides sufficient support
Rear Bevel Angle Locking Nut (57) is loose
Triton Precision Power Tools guarantees to the purchaser of this product that if any part proves to be defective
due to faulty materials or workmanship within 3 YEARS from the date of original purchase,
Triton will repair, or at its discretion replace, the faulty part free of charge.
This guarantee does not apply to commercial use nor does it extend to normal wear and tear or
damage as a result of accident, abuse or misuse.
* Register online within 30 days.
Terms & conditions apply.
This does not affect your statutory rights
Solution
Check power supply
Press the Reset Button (56), found on the underside of the
Power Inlet Box (55), then test with the ON/OFF Switch
Replace the On/Off Switch at an authorised Triton service centre
The blade will need replacing, see 'Saw blade replacement'
for instructions on how to replace the saw blade
Refasten supporting fences and ensure there is no movement
when pressure is applied
Calibrate the Saw Blade using the method described under
'Blade calibration'
Replace the sacrificial wood piece
Tighten the Rear Bevel Angle Locking Nut
oves to be defecti
GB
7