Outdoorchef DUALCHEF 315 G Mode D'emploi page 32

SERVICING THE DGS
The burners can be clogged by insects. This can impair the performance or lead to flashbacks.
Please perform the following steps to inspect and clean the burner regularly:
1
1. First, remove the barbecue grids and the DGS
2a. Next, remove the retainer clamps from the burner fixation.
2b. Then remove the top burner fixation.
2c. Next, lift the burner out of the burning chamber.
3. Clean the burner with a thin bottle brush or wire.
4. After having been cleaned successfully, the individual components are re-assembled in reverse order in the burning chamber and started as
described in the "IGNITING THE MAIN BURNERS" section.
IMPORTANT: If you use a cleaning agent for cleaning, you must allow the barbecue to dry out correctly after cleaning. To accelerate the drying
procedure, you can switch the barbecue on and let it burn out for a few minutes at the
MAINTENANCE
Regular maintenance of your DUALCHEF will ensure it functions correctly. At least twice a year, check all parts that carry gas; also check them
when you have not used them for longer periods. Spiders and other insects can cause blockages that must be cleared before use. If the barbe-
cue is regularly pushed across uneven ground, check from time to time whether all screws are still tight.
If you have not used the barbecue for a long period, you should carry out a CHECK FOR LEAKS before using it again. If you have any doubts,
please contact your gas supplier or the retailer.
To prevent damage due to corrosion, oil all metal parts before lengthy storage. Following lengthy storage, and at least once a year during the
barbecue season, you should check the gas hose for cracks, kinks and other damages. A damaged gas hose must be replaced immediately, as
described in the SAFETY NOTES chapter.
To allow you to enjoy using your barbecue for as long as possible, protect it from the effects of the weather, using a suitable OUTDOORCHEF
cover once it has cooled down completely. Remove the cover after any rain in order to prevent condensation build-up. Covers can be purchased
from your barbecue retailer.
TROUBLESHOOTING
The burner does not ignite:
• Check if the gas supply is open at the gas bottle.
• Make sure there is enough gas in the bottle.
• Check if sparks are passing between the electrode and the burner.
CAUTION: This inspection may only be performed with the gas supply fully closed!
No spark:
• Make sure that the batteries have been inserted correctly and are charged.
• The distance between the burner and electrode is only allowed to be 4-6 mm.
• Check whether the cables of the electric ignition and the electrode are plugged in and firmly connected.
• Insert 2 new batteries (type AAA, 1.5 V) in the electric ignition.
Please contact the retailer if you cannot get the barbecue to operate with reference to the measures above.
TWIN BURNERS
®
2a
PROTECTION BARS from the DUALCHEF.
®
OUTDOORCHEF.COM
2b
setting with the lid open.
32
2c