Jslow1: Slow Mode Booting Jumper; Jln1~2: Low Temperature Booting Jumper; W_Flow1: Water Flow Meter Connector - MSI MEG Z490 GODLIKE Mode D'emploi

JSLOW1: Slow Mode Booting Jumper

This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.

JLN1~2: Low Temperature Booting Jumper

This jumper is used for liquid nitrogen cooling system to boot at an extreme low
temperature. Try to set it Enabled to increase the boot success rate.
⚠
Important
∙ Users will try extreme low temperature overclocking at their own risks. The
overclocking results will vary according to the CPU version.
Please don't set to Enabled when power-off or the system will be un-bootable.
∙

W_FLOW1: Water Flow Meter Connector

This connector allows you to connect a water flow meter to monitor the flow rate of
your liquid cooling system.
30
Overview of Components
JSLOW1
Normal
(Default)
JLN1
JLN2
Normal
(Default)
1 Ground
2 WFLOW PWR
Enabled
(Please enable this jumper
during BIOS POST.)
Enabled
(Please enable this jumper
during BIOS POST.)
1
3 WFLOW IN