Télécharger Imprimer la page

Bosch 1 687 016 141 Notice Originale page 6

Jeu d'accessoires

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
en
6 | 1 687 016 141 |
Connecting high-pressure hose lines
Replace the high-pressure hose imme-
diately if the union, the sealing cone or
the sheath of the high-pressure hose is
damaged.
6. Check whether the thrust ring (fig.3, item 1) has
been tightened firmly (left-hand thread).
FD: 2010-09
1
Fig. 3:
High pressure hose
7. Remove the union nut (fig. 7, item 1) and the sealing
cone (fig. 7, item 2) at the high-pressure outlets of
the distributor rail.
8. Connect the high-pressure hose line to the high-
pressure outlet of the distributor rail (see fig.4).
Tightening torque: 25 – 30 Nm.
9. Connect the other end of the high-pressure hose
to the connection piece for the high-pressure hose
(fig. 4, item 1).
Tightening torque 25 – 30 Nm.
1
Fig. 4:
High-pressure connection with two injectors
|
1 689 989 243
2015-01-30
!
1 687 712 ...
FD: 2010-09
M=25 - 30 Nm
458847-51_Pal
2
Fig. 5:
The high-pressure hose must not lie against the pro-
tective hood of the EPS 708 when it is closed. You
can reduce the height of the high-pressure hose by
turning the connection piece (fig.5). When doing so,
make sure the bending radius of the high-pressure
hose line is more than 200 mm.
458847-48_Pal
Injector with high-pressure hose
Robert Bosch GmbH

Publicité

loading