Firmware Update - Megasat Countryman GPS plus Mode D'emploi

6. Firmware update

USB device
1. Copy the new firmware to the root directory of the USB device (without subfolders).
The flash drive must be formatted as a FAT32 file system and must not contain any
other data! You can find the latest firmware on www.megasat.tv
2. Ensure that the unit is turned off and plug the USB into USB port on the side of controller.
3. Press and hold SET button then also press the POWER button.
4. The update starts. During this time, the satellite LEDs will light up one by one.
5. After a successful update, the control unit switches off and restarts.
ENGLISH
11