Operation And Usage; Switching On; Choose Satellite - Megasat Campingman Kompakt Mode D'emploi

4. Operation and Usage

4.1 Switching on

Function Description
Standby
Standby Standby

4.2 Choose satellite

Function Description
4.3 Search satellite
Function Description
08
Press the
power switch
"Standby Position"
lights solid
"Standby Position"
flashes
lights solid
Choose satellite
(up/down)
OK button
Satellite LED
Operation
When the all cable connections are completed, switch
on with the "Power Switch" button on the top of the
controller.
If the position of antenna was in basic position, "Standby
state light" will be solid on to show it is Standby to use.
If the position of antenna was not in the basic position,
"Standby state light" will flash, and the antenna will return
to the basic position within a maximum 2 minutes. Then
"Standby state light" will be solid on.
Operation
Once antenna and controller are connected, you can
select and change the satellite as you require.
Select the desired satellite using the up/down buttons,
then press the OK button to accept the setting.
If you select the wrong satellite, you can re-search target
satellite using the up/down buttons, then press the OK
button to accept the new setting.
Operation
After the satellite selection, "Standby state" light will go off
and the LED light of the selected satellite will start
flashing.
Once selected satellite has been found, the LED light of
the satellite will become solid.
ENGLISH