Graf KLARO Easy Notice D'installation page 51

5.5.2 Outlet pipe with sampler
An 8.5 mm hole is required in the sampler in order to fasten the internal sampler.
The sampler is then positioned in the middle of the tank in the outlet direction, as shown in the image
above, and fixed to the crossbar using nuts and screws. The connection between the sampler and socket
of the outlet pipe is fixed using Spax screws.
5.6 Holding plate for SBR reactor with 2-tank systems
In 2-tank systems a holding plate is installed in the SBR reactor for securing the lifters. The installation of
the holding plate is described in the following sections.
5. Installation of the setting-up kit
Tank size
2700 l
3750 l
4800 l
6500 l
Screw
M8x30
50 / 148
H
H
150 mm
130 mm
120 mm
70 mm
Holding plate for 2-tank systems