Frigidaire ATF705X Notice D'utilisation page 6

Control Panel, continued
5
Select Button
6
Soil Level Button
7
Cancel/Reset Button
8
Start/Pause Button
Door Lock Pilot Light
9
and Programme
Phase Pilot Lights
10
Display
11
Delay Start Button
6
By pressing this button you can confi rm or delete the options selected by means of button 4.
By pressing this option you can select or delete one of the following soil level:
• Quick: By selecting this option the wash duration decreases. The display will show the
shorted washing time. To be used for lightly soiled laundry only. Recommended for smaller
loads (for more details see «Programme table»).
• Daily: By selecting this button the wash duration decreases. To be used for normally soiled
laundry.
• Heavy: By selecting this option the wash duration increases.
Press this button to stop the wash programme.
Press this button to start, pause or restart a wash programme.
Door Lock:
• Light on: The door cannot be opened.
• Light blinking: The door lock is releasing. The appliance has been probably set to pause.
• Light off: The door can be opened.
Note
Do not try to force the door open when Door Lock light is on.
The following pilot lights indicate which wash phase the appliance is carrying out:
Wash: During the wash phase.
Rinse: When the appliance is rinsing.
Final Spin: When the appliance is spinning.
The display shows the following information:
• The duration of the selected programme: After selecting a programme the duration of the
selected programme appears on the display.
• Select the delayed start by pressing the button 11. Press this button to select the required
delay. The selected delay time value will appear on the display for few seconds, then the
duration of the programme will appear again. You must select this option after you have
set the programme and before you press the button 8.
PAU
• Message " " (PAUSE): It is displayed alternately with the estimated time remaining when
the cycle is paused.
LOC
• Message " " (LOCK): It is displayed alternately with the estimated cycle time when you
lock the controls.
• If you try to start the programme and the door is open, the message "
played.
PF
• Message " " (POWER FAIL): It is displayed alternately with Message "
power supply break has occurred and the appliance is not operating. Press the button 8 to
restart the wash programme.
By means of this buttons, the wash programme can be delayed from 30 min - 60 min - 90
min, 2 hours and then by 1 hour up to a maximum of 14 hours.
DR " (DOOR) is dis-
PAU
" to indicate that a