Installation And Operation - Abus RWM140 Manuel Utilisateur

Choosing a location
The smoke alarm should not be installed in the following areas
• outside (use only in internal rooms);
• in areas in which the alarm can be triggered by disturbances (steam,
condensation, 'normal' smoke, fumes, dust, dirt or grease);
• next to ventilation or similar air inlets (draughts);
• in areas where temperatures may fall below 0° C or exceed 40° C.

Installation and operation

In order to mount the alarm on the ceiling,
follow the steps in the order listed below:
1. Remove smoke alarm from the cover base
by turning anti-clockwise.
2. Remove the locking pin located in the
mounting socket (further use in step 7,
is used for unintentional disassembly).
3. Mark the holes through the cover base.
4. Fit the required rawlplug into the drill hole
and tightly screw in the detector base.
When marking out your drill holes, ensure that no electrical wires
cables, pipes or other installation components are located behind
the installation point!
5. Then enter the current date (installation date)
on the label on the reverse side of the alarm
with a water and abrasion resistant pen
(see illustration opposite).
Installationsdatum | Installation date | Date
d'installation: _____________ (DDMMYYYY)
– 33 –
Installation and operation
z. B. : 02|01|2019
GB