INVENTOR COOL Mode D'emploi page 20

Install drainage pipe
Note: Install drainage pipe prior to use, or poor drainage may possibly affect the normal operation
of the unit.
1. Remove the drainage plug from the drainage port.
2. Screw firmly the drainage pipe clip on the right of the rear side plate located near the drainage
port.
3. Attach the drainage pipe into the drainage port and position upwards into the plastic clip and
then bind with the pipe hoop.
4. Attach the rubber plug into the other side of the drainage pipe, fasten with the pipe hoop, while
the other end is fit in the drainage pipe.
rubber plug drainage port
drainage port
drainage pipe
rubber plug
pipe hoop
drainage port
18
drainage pipe clip
screw
pipe hoop
drainage
pipe clip