Care And Maintenance - INVENTOR EPC-09 Mode D'emploi

CARE AND MAINTENANCE

Air filter (take
out)
Fig.24
Air filter
(install)
Fig.25
CARE AND MAINTENANCE
IMPORTANT:
1. Be sure to unplug the unit before cleaning or servicing.
2. Do not use gasoline, thinner or other chemicals to clean
the unit.
3. Do not wash the unit directly under a tap or using a
hose as it may cause electrical shock.
4. If the power cord becomes damaged it must be re-
placed from the product manufacturer and never
repaired.
1. Air filter
- Clean the air filter every two weeks to prevent
inferior fan operation due to dust.
- Removal
Take the air filter out using the arrow direction
(Fig.24).
- Cleaning
Wash the air filter by immersing it in warm soapy
water (about 40°C/104°F) using a mild detergent.
Rinse the filter and dry it in a shady place.
- Mounting
Install the air filter after cleaning (see Fig.25).
NOTE: The grill and the air filter are connected and
can be separated.
2. Unit enclosure
- Use a lint-free cloth and soapy water (using a mild
detergent) to clean the unit enclosure. Dry with a
clean cloth.
3. Storing or not using the unit for extended
periods of time
- Remove the rubber plug at the back of the unit and
attach a hose to the drain outlet. Lead the open
end of the hose to the desired drainage receptacle
(See Fig.22 & 23).
- Remove the plug from the bottom drain outlet;
allowing the water in the bottom tray to drain out
(See Fig.24).
- Keep the appliance running on FAN mode for half a
day in a warm room to dry the inside of the appli-
ance, preventing mold.
- Turn off the appliance and unplug it, wrap the cord
and bundle it with the tape. Remove the batteries
from the remote control.
- Clean the air filter and reinstall it.
16