INVENTOR EPC-09 Mode D'emploi page 13

Window.
panel
or
Window.
panel
or
Foam seat
Foam seal A
(adhesive type)
Fig.12
26.5 ~ 48.0
26.5 ~ 48.0
Fig.13
Fig.14
Fig.15
INSTALLATION INSTRUCTIONS (optional)
Installation in a sliding sash window
1. Cut the foam seal (adhesive type) to the proper length
and attach it to the window frame. See Fig. 12.
2. Attach the window slider kit to the window sill.
3. Adjust the length of the window slider kit according to
the width of window, shorten the adjustable window kit
if the width of window is less than 26.5 inches. Open
the window sash and place the window slider kit on the
window sill. See Fig. 13.
4. Cut the foam seal (adhesive type) to the proper length
and attach it on the top of the window.
See Fig. 14.
5. Close the sliding sash securely against the window.
6. Cut the foam seal to an appropriate length and seal
the open gap between the top window sash and outer
window sash. See Fig. 15
13