Ribimex Ribiland PRTRT450 Manuel D'instructions Et D'utilisation page 38

6.3.2- Guide Bar
- Reverse the bar occasionally to prevent partial
wear.
- The bar rail should always be square.
Check for wear of the bar rail. Apply a ruler to the
bar and the out side of a cutter.
If a gap is observed between them, the rail is
normal. Otherwise, the bar rail is worn.
Such a bar needs to be corrected or replaced.
6.4- Transport
1. Switch off the engine when moving the product.
Caution: After stopping the engine, the metal parts (e.g. muffler) are still hot.
Never touch the hot parts. Allow them to cool down before handling the machine.
2. Check there is no leakage of fuel.
3. Warning! Always cover the chain and the chain guide protective sheath for transport.
4. When transporting in a vehicle, be sure to firmly secure the product with no party extends outside
the vehicle to avoid a risk (e.g. fall, injury, damage; ...)
6.5- Cleaning
Clean plastic parts with a soft clean cloth.
Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive sponge.
Do not put or immerse product in water or any other liquid.
Clean ventilation holes with a soft brush.
6.6- Storage
Clean the machine before storage.
Perform maintenance operations before storage.
For prolonged periods of storage, drain the oil and gasoline from the tanks, and lubricate the chain
and moving parts.
Cover the chain and guide bar with the protective sheath.
Product must be stored in a dry clean location, protective from frost and excessive heat. Always lock
up product and keep out of reach of children
6.7- Disposal
- Cutting remnants: do not throw with household rubbish or in the environment. Dispose of cutting
remnants in rubbish collection centres or seek advice from your local municipality.
- Machine: do not dispose with household garbage. Do not throw into the environment.
Dispose of the product in a collection centre for waste or seek advice from your local municipality.
Before disposal, drain oil and mixture from the tanks and dispose according to your local regulations.
- Proceed with disposal of remnants, machine, accessories and packaging according to local
regulations regarding the protection of the environment.