Connecting The Monitor To A Power Source; Turning The Power On - Sharp LL-T19D1 Mode D'emploi

Connecting the monitor and turning the monitor on and off
Connecting the monitor to a power
source
Power terminal
Power cord

Turning the power on

1.Turn on the main power of the monitor.
Main power switch
AC outlet
- When switching the main power switch on and
2.Press the monitor's POWER button.
The power LED will light up orange.
3.Turn on the computer.
When a signal is input from the computer, the
power LED lights up green, and the screen is
displayed. (After power is turned on, it may take a
little time until the screen is displayed.)
- If the input terminal to which the computer is
Notes:
- When using an analog signal, perform an
automatic screen adjustment under the following
conditions (p.16):
- Using the monitor for the first time.
- After having changed the system settings
- Depending on the computer or OS, it may be
necessary to use the computer to install monitor
set-up information (p.26).
- When connecting to a notebook, if the notebook
computer's screen is set so that it is displaying at
the same time, the MS-DOS screen may not be
able to display properly. In this case, change the
settings so that only the monitor is displaying.
12
off, always wait for an interval of at least 5
seconds. Rapid switching may result in
malfunction.
Press power button.
connected has not been selected, the screen
will not be displayed. If necessary, perform
input terminal switching. (p.13)
during use.
Turn on the
computer power
supply.
ON