Radio Cloning; Wireless Cloning - Albrecht Tectalk Duro XS Mode D'emploi

1. Radio Cloning

1.1. Wireless Cloning

1 Put together the master radio and the slave radios. (within
about 20cm)
2. Turn on the master radio pressing PTT button and Mode(M)
button simultaneously.
The radio LED blinks green.
3. Turn on the slave radio or radios pressing PTT button and
Mode(M) button simultaneously.
The radio(radios) LED blinks green too.
4. Press and hold the master radio until the master radio LED
charges green as well as the slave radio(s) charger green.
During cloning, the slave radio(s) blinks among green, orange
and red.
5. Turn off your radios and turn on again.
1.1. Wired Cloning
The cloning process using a cloning cable is basically same as
that using the wireless cloning.
You could use this wired cloning around noisy circumstances
that could give interferences.
1. Connect two radios(the master and the slave) using a cloning
cable.
2. Just follow the above process No.2 through No.5.
3. Disconnect the cloning cable from the radios.
English 41