Samsung DW60R2014US Mode D'emploi page 22

Installation
STEP 8 Final check
1. Remove all foam, paper packaging, and unnecessary parts from inside the dishwasher.
2. Turn the circuit breaker on.
3. Open the water valve to supply water to the dishwasher.
4. Plug in the dishwasher.
5. Turn the dishwasher on, and then select and run a cycle.
6. Check if the dishwasher turns on normally and if there are any water leaks while the
dishwasher is operating. Make sure to check for water leaks on both ends of the water
line and the drain hose connector.
7. Check if the kick plate gasket is attached to the bottom of the kick plate. To install the
kick plate, see the Kick plate section below.
Kick plate (BU model only)
If you want to install the kickplate, follow these instructions.
22 English
DW60R2014(A5)_IM_DD81-02707A-00_EN.indd 22
1. Turn the front legs of the dishwasher to
adjust the height so that the kick plate
fits in.
2. Attach the kickplate to the dishwasher
using the kickplate brackets. Make sure
the kickplate brackets are in the correct
direction. See the figure for details.
2019-02-20 3:00:34