Samsung DW60R2014US Mode D'emploi page 11

STEP 2 Connect the hot water line
• The water line pressure must be between 20 psi and 120 psi (140–830 kPa).
• Make sure that the water temperature is delivered between 120 °F and 149 °F (49-
60 °C). Exceeding this limit may cause the dishwasher to malfunction.
• Make sure that the circuit breaker and water valve is turned off before connecting the
water supply line to the dishwasher.
• Make sure the water line is properly connected. Wrap Teflon tape around every
connection and joint to prevent water leaks.
a
A
B
c
E
F
3/16"
(5 mm)
Inlet valve
DW60R2014(A5)_IM_DD81-02707A-00_EN.indd 11
b
C D
Water
valve
90° elbow Hot water
fitting line
1. Use the provided nut connector
to connect the water hose to the
dishwasher.
Follow these steps:
a. Disconnect the 90° fitting (A) from
the hose (B).
b. Remove the seal (C) and the nut (D)
from the 90° fitting.
c. From the provided nut connector,
separate the seal (E) and the nut (F),
and then assemble them to the 90°
fitting as shown in the figure. You
must insert the smaller side of the
seal.
2. Insert the 3/4" 90-degree fitting into the
inlet valve. Tighten the fitting until it
points towards the water-hose channel
in the base of the dishwasher. Do not
overtighten.
3. Connect the hot water line to the fitting.
4. If you want to secure the dishwasher to
the side wall for extra stability, bend the
brackets of the left and right housings
by referring to the figure.
English English 11
2019-02-20 3:00:28