Samsung DW60R2014US Mode D'emploi page 21

1 in.
(24 mm)
Sink
Min. 30 in.
(762 mm)
Min. 20 in.
Drain
(508 mm)
hose
CAUTION
• Use caution not to damage the drain hose when installing the dishwasher.
• Install the drain system properly so that the drain hose does not disconnect from the
drain outlet in the draining process.
• Make sure that the drain hose, supply hose, or power cord is not kinked or folded.
DW60R2014(A5)_IM_DD81-02707A-00_EN.indd 21
1. Check the size of the sink's drain hose
If the drain hose does not fit into the sink
5/8 in. connector, you can purchase an adaptor at
3/4 in.
(15 mm)
a plumbing/hardware store.
(18 mm)
2. Insert the drain hose into the sink
3. When drilling a hole for the drain hose
Dishwasher
4. Secure the drain hose to the sink wall
5. If there is no air gap, make sure to hang
connector. If needed, cut the drain hose
so its end fits into the sink connector.
NOTE
connector, slide the hose clamp to the
end of the hose, and then tighten the
hose clamp.
on the cabinet wall, use caution not to
damage the drain hose on the sharp
edges of the hole.
- On wooden walls, use sand paper to
soften the edges.
- On metal walls, use insulation tape or
duct tape to cover the sharp edges
around the hole.
using cable ties or other fastening
materials.
the middle of the drain hose well above
the sink cabinet base to prevent back-
flow (See the image on the left side).
English English 21
2019-02-20 3:00:34