Bowers & Wilkins 705 S2 Mode D'emploi page 9

5. Running In
The performance of the speaker will change subtly during the
initial listening period. If the speaker has been stored in a cold
environment, the damping compounds and suspension materials
of the drive units will take some time to recover their correct
mechanical properties. The drive unit suspensions will also loosen
up during the first hours of use. The time taken for the speaker to
achieve its intended performance will vary depending on previous
storage conditions and how it is used. As a guide, allow up to
a week for the temperature effects to stabilise and 15 hours of
average use for the mechanical parts to attain their intended
design characteristics.
6. Aftercare
The cabinet surfaces will usually only require dusting. If you wish
to use an aerosol or other cleaner, apply the cleaner onto the
cloth, not directly onto the product and test a small area first,
as some cleaning products may damage some of the surfaces.
Avoid products that are abrasive, or contain acid, alkali or
antibacterial agents. Marks on the paint surface may be removed
with a dilute perfume-free soap solution. Remove any remaining
streak marks by spraying with a proprietary glass cleaner and
lightly wiping dry with a microfibre cloth. Do not use cleaning
agents on the drive units and avoid touching them as damage
may result.
Real wood veneers are treated with an ultra-violet resistant
lacquer to minimise changes in colour over time. Nevertheless,
like all natural materials, a degree of colour change is to be
expected. Colour differences may be rectified by exposing
all the veneer surfaces equally and evenly to sunlight until the
colour is uniform. This process can take a long time, but may
be accelerated by careful use of an ultra-violet lamp. Keep the
speakers away from direct sources of heat such as radiators and
warm air vents in order to minimise the possibility of the wood
veneer cracking.
9