Télécharger Imprimer la page

Topmodel BIDULE 170 ECOTOP Mode D'emploi page 34

Publicité

CENTRAGE
Centrage: A l'atelier, prêt au vol, porter le modèle sur les index de chaque côté du fuselage, à l'emplanture de l'aile, après avoir reporté
CG LOCATION
les repères de centrage (voir schéma ci-dessous).
Si le modèle penche vers l'avant (nez lourd) déplacer l'accu de propulsion vers l'arrière.
Si le modèle penche vers l'arrière (queue lourde) déplacer l'accu de propulsion vers l'avant.
L'avion est correctement centré quand il penche très légèrement vers l'avant avec les index pile-poil à cheval sur les
repères.
Plage de centrage: 185-195 mm du bord d'attaque à l'emplanture de l'aile.
Notes: Le centrage s'obtient sans plomb avec les équipements recommandés (changer la position du pack d'accu de propulsion si
nécessaire).
Balance: In workshop, ready to fly, carry the model on the fingers on each side of the fuselage at the wing root, after having drawn the
balance marks (see photo below).
If the model leans forwards (nose heavy), move the battery backwards.
If the model leans backwards (tail heavy), move the battery forwards.
The plane is correctly balanced when it leans very slightly forwards with the index on the reference marks.
CG location determines (inter alia) the stall characteristics.
CG range from 185-195 mm measured from the leading edge at the root of the wing.
Note sur les réglages:
Les réglages donnés ici le sont à titre indicatif, pour notre prototype centré à 190mm du bord d'attaque à l'emplanture.
Il convient à chaque modéliste d'adapter ces réglages conseillés, à ses propres habitudes et convenances.
Note about settings:
The settings shown here are indicative, for our prototype balanced at 190mm from the leading edge at the root of the wing.
It is suitable for every modeller to adapt these recommended settings, its own habits and conventions.
DEBATTEMENTS
CONTROLS THROWS
190 mm
1
cran/1
slot
er
st
2
cran/2
slot
ème
nd
Compensation Profondeur à
piquer/Mix Elev down
1
cran/1
slot
er
st
2
cran/2
slot
ème
nd
35mm
30mm
VOLETS/FLAPS
40mm
100mm
-3mm
-8mm
AIL
34
30mm
25mm
PROF/ELEV

Publicité

loading

Ce manuel est également adapté pour:

066170