Normal Operatingdisplay; Lamp Hours Display; Light Brightness Control; Standby - Sunoptic Surgical Titan X450 Mode D'emploi

6.2.2 NORMAL OPERATINGDISPLAY

6.2.2.1
Shows total lamp on hours.
6.2.2.2
The user may adjust the light brightness by touching the minus
controls on thenormal operating displaytouch screen.
NOTE The brightness control operates a progressive electro-mechanical shutter. The
lamp is running at full power if the power switch is on no matter where the
brightness control is set.

6.2.2.3 STANDBY

Touching STANDBY
(not strobe) flashes the word "STANDBY" on/off in one second Intervals. Touching
STANDBY again while in STANDBY mode will restore the light to the preset brightness
value showing on the screen.
6.2.2.4
The MENUbutton gives the operator access to five functions of information and control.
Repeatedly touching the MENU button will cycle through the five MENU functions, as follows:
LIT-219 Sunoptic Surgical
Rev. C
LAMP HOURS
Lamp Hours :
_
100

MENU

LIGHT BRIGHTNESS CONTROL

Lamp Hours :
_
100
MENU
dims the light by moving the shutter to fully occlude it and "softly"
MENU
®
Page 15 of 169
950
+
STANDBY
Intensity Adjust
or plus
950
+
STANDBY
Intensity Adjust
(English)