Saeco Incanto HD8917 Mode D'emploi page 36

English
36
Problem
The machine grinds the
coffee beans, but coffee
does not come out.
The coffee comes out
slowly.
The frothed milk is
too cold.
The milk does not froth. The classic milk frother is dirty or
There is water under
the machine.
4219_460_3631_2_Lux_Booklet_A5_v2.indd 36
Cause
The coffee exit duct is blocked.
The grind is set to a too fine
setting.
The brew group is dirty.
The coffee dispensing spout is
dirty.
The coffee is grind too finely.
The brew group is dirty.
The coffee exit duct is blocked.
The machine circuit is blocked
by limescale.
The cups are cold.
not assembled correctly.
The type of milk used is not
suitable for frothing.
The drip tray is too full and
overflowed.
The machine is not placed on a
horizontal surface.
Solution
Clean the coffee exit duct with
the handle of the multifunctional
tool or a spoon handle.
Adjust the grinder to a coarser
setting.
Clean the brew group.
Clean the coffee dispensing
spout and its holes with a pipe
cleaner.
Use a different coffee blend or
adjust the grinder.
Clean the brew group.
Clean the coffee exit duct
with the handle of the
multifunctional tool or a spoon
handle.
Descale the machine.
Preheat the cups by rinsing
them with hot water.
Clean the classic milk frother
and make sure it is correctly
assembled.
Different types of milk result in
different amounts of froth and
different froth qualities. We
have tested the following milk
types which proved to deliver
a good milk froth result: semi-
skimmed or full-fat cow's milk,
soy milk and lactose-free milk.
Other types of milk have not
been tested and may result in
a small amount of milk froth.
Empty the drip tray when the
'drip tray full' indicator pops up
through the drip tray. Always
empty the drip tray before you
start descaling the machine.
Place the machine on a
horizontal surface so that the
'drip tray full' indicator works
properly.
21/07/17 14:30