Saeco Incanto HD8917 Mode D'emploi page 35

Problem
I cannot insert the brew
group.
The coffee has too little
crema or is watery.
Coffee is leaking from
the coffee dispensing
spout.
The coffee is not hot
enough.
4219_460_3631_2_Lux_Booklet_A5_v2.indd 35
Cause
The brew group is not in the
correct position.
The machine is still in the
descaling procedure.
The grinder is set to a too coarse
setting.
You are using an unsuitable
coffee blend.
The machine is performing its
self-adjustment.
The brew group is dirty.
The coffee dispensing spout is
clogged.
The cups you use are cold.
The temperature is set too low.
Check the menu settings.
You added milk.
English
Solution
You did not put the brew
group in neutral position
before placing it back. Make
sure that the lever is in contact
with the base of the brew
group and that the hook of the
brew group is in the correct
position.
Reset the machine by turning
it on and off. Place the drip
tray and the coffee grounds
container back. Leave the
brew group out. Close the
maintenance door and turn the
machine on and off. Then try
to reinsert the brew group.
You cannot remove the
brew group when the
descaling process is active.
First complete the descaling
process and then remove the
brew group.
Adjust the grinder to a finer
setting.
Start using a different coffee
blend.
Brew a few cups of coffee.
Clean the brew group.
Clean the coffee dispensing
spout and its holes with a pipe
cleaner.
Preheat the cups by rinsing
them with hot water.
Set the temperature to 'high' in
the menu.
Whether the milk you add
is warm or cold, it always
decreases the temperature of
the coffee to some extent.
35
21/07/17 14:30