6 - Main menu
09:
H:
C:
01:
02:
03:
150
Mode
Zone state
Not connected
ON/OFF
OPEN/CLOSE
FAN–COIL 3V
FAN–COIL 3V
FAN–COIL 3V
GATEWAY
ON/OFF
OPEN/CLOSE
Zone test . . .
Living room
Zone 2
Zone 3
Pumps
Current profiles
Programming
One of the following options can be selected
for each actuator in the list:
Fan-coil with control of one valve and selector switch up to 3
speeds
Interface for Climaveneta Fan-coil
Load managed by just one contact (e.g.: thermostatic valve)
Load managed by two interlocked relays (e.g. motor-driven
valve with opening contact and closing contact)
Press the
to the zone
The control unit tests the configuration.
When this is finished there may be two error
messages:
Configuration
Trying to set a configuration of actuators which is
not allowed (example: actuators of different type
for the same function) in a probe
configuration
Check that the probe is in standard configuration
(MOD=CEN) and try again; if it is not this type of
configuration, the control unit cannot configure
the probe.
Setup
key to send the configuration set
invalid
ERROR
Verify the
probe
Maintenance
Maintenance