Programming; Programming From Personal Computer - LEGRAND 674 56 Notice D'installation

5 - Programming

5.1 - Programming from personal computer

Type of program
The Unit can be programmed by using the ThermoConfig software.
Programming from a PC requires a cable 492 34, for the connection between the Unit 6-way
connector and a PC USB port.
Connection is carried out as follows:
Use the maintenance code to enter the Maintenance using the Maintenance menu, take the
Unit OFF the bracket.
Start ThermoConfig program.
Connect cable when requested and then follow the program procedure
Made in Italy
REMOTE
492 34
BUS
For further information, see ThermoConfig software manual.
Firmware update
This function allows updating the Unit software with its latest release. Such update allows bringing
in improvements as well as new Unit functions.
The latest firmware releases are available at www.legrandelectric.com
Before starting the firmware updating procedure position the slide switch on OFF
For further information, see ThermoConfig software manual.
100