1.GENERAL NOTICE
This manual is intended for owners, installers, users and maintenance personnel of the ALMA-AURA series stoves and is an
integral
part of the product. FONTANA FORNI SRL heating appliances are built and tested in accordance with the safety requirements
specified
by the European directives. Faulty stoves or mechanical and electrical components are covered under a two-year warranty.
During the warranty, disassembling or replacement of the stove spare parts must be carried out by your Service Retailer.
Unauthorized disassembling or replacements void the manufacturer's warranty. Any damage due to improper use of the stove
will not be covered under warranty. The present manual contains instructions for the following stove models: PELLET STOVE
ALMA-AURA.
2.SYMBOLS
The following is a report of the symbols used in the manual. They draw the reader's attention to possible dangers during
installation and use..
WARNING/DANGER: The texts marked by this symbol contain relevant safety information and imply
potentially dangerous situations or operations.
VOLTAGE: High voltage and danger of electricity shock.
GLOVES MANDATORY: This symbol means that gloves are compulsory for the operator in order to avoid
accidents.
WARNING: Hot surfaces
3.PURPOSE AND CONTENTS OF THIS MANUAL
The purpose of this manual is to provide the fundamental information for a correct installation, maintenance and use of the
product. By delivering the present manual we decline any legal liability for accidents that may occur because the user has not
followed, or only partly followed, the instructions of the present manual.
4.INTENDED USE
ALMA-AURA is a wood pellet stove for domestic use. Comply with the following instructions concerning the use of the stove:
Do not open the door when the stove is operating. The appliance is not intended for use by persons with limited physical,
sensory or mental capacities, or with insufficient experience or knowledge. The appliance is not intended for use by children.
Make sure children do not get close to the stove while it is operating. The above described intended use of the stove and the
relative configurations are the only ones permitted by the manufacturer: never use the stove in ways not described in the
provided instructions.
5.GENERAL INFORMATION
The identification label on the back of the stove (figure 1 and 1a) contains all the relevant information to clearly and univocally
identify the manufacturer, the serial number and the EC marking. Extraordinary maintenance must be carried out by qualified
personnel authorized by the manufacturer. The manufacturer is not responsible for the consequences of improper installation,
therefore the installer is fully responsible for the above mentioned non-complaint installation, unauthorized changes and/or
repairs and use of non-original spare parts. The stove is to be used in compliance with the instructions contained in this manual
and safety standards set by the specific local legislation where the stove is installed.
6.SAFETY STANDARDS
A)Directive 2006/95/EC: "Electrical equipment designed for use within certain voltage limits; B) Directive 2004/108/EC;
"Approximation of the laws of the Member States relating to electromagnetic compatibility". C)Directive 89/391/EEC:
"Introduction of measures to encourage improvements in the safety and health of workers at work". D)Directive 89/106/EEC:
"Approximation of laws, regulations and administrative provisions of the Member States relating to construction products".
E)Directive 85/374/EEC: "Approximation of the laws, regulations and administrative provisions of the Member States concerning
liability for defective products". F)Directive 1999/5/EC: "Radio equipment and telecommunications terminal equipment and the
mutual recognition of their conformity". G) UNI 14785/2006: "Residential space heating appliances fired by wood pellets -
Requirements and test methods". EN 60335-1; EN 50165; EN 50366; EN 55014-1; EN 61000-3-2; EN 14785; EN 61591; EN 60704-
3; EN 60704-2
Notice d'installation, d'utilisation et d'entretien
37