CARE, MAINTENANCE & TROUBLESHOOTING
WARNING: To prevent electrical shock, please turn off and unplug the treadmill before
cleaning or performing routine maintenance.
WARNING: Always check the wear and tear components like spring knob and running belt to
prevent injury.
CLEANING
After each exercise, ensure that the unit is wiped down and any sweat is removed from the unit.
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives or solvents.
Be careful not to get excessive moisture on the display panel as this might damage the unit and
create an electrical hazard.
Please keep the treadmill, especially the computer console, out of direct sunlight to prevent damage
to the screen.
STORAGE
Store the treadmill in a clean and dry indoor environment. Never leave or use the unit outdoors.
Ensure the master power switch is off and the power cord is un-plugged from wall outlet.
TROUBLESHOOTING GUIDE
Problem
Treadmill will not start.
Belt slips.
Belt hesitates when stepped on. 1. Not enough lubrication ap-
Belt is not centred.
Potential Causes
1. Treadmill not plugged in.
2. Safety Tether Key is not
correctly installed.
3. Circuit breaker in the
house has been tripped.
4. Treadmill circuit breaker
has been tripped.
Belt not tight enough.
plied onto the running deck.
2. Belt is too tight.
Running belt tension not even
across the rear roller.
42
Corrections
1. Plug the power cord into a
wall outlet.
2. Reinstall the SafetyTetherKey.
3. Reset the circuit breaker,or
call an electrician to replace the
circuit breaker.
4. Wait 5 minutes and then try
to restart the treadmill.
Adjust belt tension.
1. Apply lubricant.
2. Adjust belt tension.
Centre the belt.