Troubleshooting Guide - SPORTSTECH F17 Manuel

BELT ADJUSTMENT
• Place treadmill on a level surface.
• Run the treadmill at 6-8km/h.
• If the belt has drifted to the right, turn the right bolt clockwise a 1/2 turn and turn the left bolt
anticlockwise a 1/2 turn (Picture C).
• If the belt has drifted to the left, turn the right bolt anticlockwise 1/2 turn and turn the left
bolt clockwise a 1/2 turn (Picture D).
• Test for at least 15 seconds at 4km/h (check and adjust a further quarter or half turn until the
belt is centered.
NOTE: The running belt should not be tightened too hard as this can cause noise and damage the machine.
Problem Possible Causes
E01 Console communication failures
E02 Motor failure
E03 Speed sensor failure
E04 Motor Circuit disconnection
E05 Over current protection
E06 The supply voltage is too low
E07 Check the safety lock

TROUBLESHOOTING GUIDE

34
Note
Drives do not receive a digital signal
With inductive drive